| Product Showcase | Content |
|---|---|
| Product Name | Reclaimed Water Irrigation Pump Skid |
| Product Image |
![]() Representative pump station image; supplied equipment is configured for each project. |
| Product Overview | The Reclaimed Water Irrigation Pump Skid is a factory-assembled pumping package designed to deliver treated, fit-for-purpose water from a storage tank or reservoir to an irrigation distribution network. It can serve commercial pig farms, livestock facilities, agricultural estates, and integrated wastewater reuse projects. Pump selection and wetted materials are matched to the treated water quality and the required duty point. |
| Key Features |
|
| Structural Components | A typical package includes a structural steel skid frame, pump and motor assembly, suction and discharge manifolds, isolation and check valves, pressure instrumentation, and an electrical control panel. Depending on the water source and irrigation design, the package may also incorporate a strainer or filter, flow meter, pressure relief device, air release provision, and level or dry-run protection. |
| Working Principle | Treated reclaimed water enters the suction manifold from a storage tank or other approved source. The pump raises its pressure and sends it through the discharge manifold to the irrigation network. Pressure feedback can regulate pump speed where a variable frequency drive is specified. Protective devices respond to conditions such as low source level or abnormal pressure. Required filtration and disinfection should be completed according to the intended irrigation use and local rules before water enters the distribution system. |
| Technical Specifications |
|
| Applications | Suitable for distributing appropriately treated reclaimed water to permitted crop irrigation, landscape irrigation, shelterbelts, and other approved non-potable uses at commercial pig farms and livestock sites. The skid can be coordinated with farm wastewater treatment equipment, reclaimed water storage, buried distribution mains, and irrigation controls. Use near animal housing or steel structure farm buildings should account for access, drainage, and protection of electrical equipment. |
| Customization Options | Pump configuration, control logic, manifold arrangement, filtration interface, enclosure, corrosion protection, and monitoring signals can be tailored to the project. Selection is based on the irrigation schedule, pipe network losses, storage level, reclaimed water characteristics, local climate, and farm conditions. |
| Installation & Maintenance | Place the skid on a level, load-bearing foundation with sufficient clearance for lifting and service. Connect the suction and discharge lines without imposing excessive pipe loads on the pump nozzles, then complete electrical wiring, control interlocks, and commissioning checks. During operation, inspect strainers or filters, seals, valves, instruments, and electrical alarms at intervals appropriate to the water quality and operating hours. Protect exposed piping and controls from freezing or severe weather where required. |
| Product FAQ |
Can the skid pump untreated livestock wastewater? Can it supply several irrigation zones? What information is needed for selection? |
| Product Gallery |
![]() Representative images illustrate pump station configurations and construction details; actual equipment may differ. |

Comments & Inquiries
Leave your questions or requirements below. We will reply as soon as possible.