Automatic Boot Washing and Disinfection Station

• Compact stainless steel boot cleaning structure
• Dense nylon brush assembly around the boot cleaning area
• Integrated PU liquid supply tubing
• Upper support handle for stable operation
• Open stainless steel foot platform for drainage
• Optional hose-assisted cleaning configuration

• 304 Stainless Steel Structure: Corrosion-resistant construction is suitable for wet livestock farm and sanitation environments.
• Durable Nylon Brushes: Dense brush bristles help remove manure, mud and other contamination from farm footwear.
• PU Water Lines: Flexible liquid tubing provides reliable water or compatible cleaning-solution delivery.
• Compact Footprint: Overall dimensions of approximately 700 × 310 × 810 mm allow installation in entrances and narrow biosecurity passages.
• Integrated Support Handle: Provides additional stability while boots are being cleaned.
• Easy-to-Clean Construction: Open stainless steel structure allows convenient rinsing and drainage after use.
• Boot Washing & Disinfection: Can be integrated with compatible detergent or disinfectant procedures according to farm hygiene protocols.
• Biosecurity Support: Helps reduce the transfer of contamination on footwear between livestock production zones.

• Pig farm personnel entrances
• Poultry farm hygiene passages
• Cattle and dairy farm entrances
• Breeding farm biosecurity zones
• Quarantine and isolation facilities
• Changing-room transition areas
• Veterinary and laboratory entrances
• Feed and agricultural production facilities
• Clean-zone and dirty-zone footwear control points

• Install the station on a level, non-slip floor near a suitable water supply and drainage point.
• Position the unit at controlled farm entrances where personnel can clean footwear before entering or leaving production areas.
• Check all PU tubes, valves and fittings for secure connections before operation.
• Remove accumulated mud, manure and organic material from the brushes regularly.
• Rinse brushes and stainless steel surfaces with clean water after intensive use.
• Use only cleaning agents and disinfectants compatible with the equipment materials.
• Follow the disinfectant manufacturer's recommended concentration and contact time.
• Inspect nylon brushes periodically and replace them when significantly worn or damaged.
• Keep the drainage area clear to prevent standing contaminated water.
• Clean and dry the station when it will remain unused for an extended period.

Q: What material is the boot washing station made from?
A: The main structure uses 304 stainless steel together with flat steel components for durability in wet farm environments.

Q: What material are the brushes made from?
A: The listed brush material is durable nylon.

Q: What are the dimensions?
A: The specified overall dimensions are approximately 700 × 310 × 810 mm.

Q: Can the unit clean livestock farm boots?
A: Yes. The brush arrangement is designed to remove mud, manure and other contamination from washable farm footwear.

Q: Can disinfectant be used with the station?
A: Yes, provided the disinfectant is suitable for footwear sanitation and compatible with the equipment materials. Follow the chemical manufacturer's instructions.

Q: Why should boots be cleaned before disinfection?
A: Removing visible dirt and organic matter helps the subsequent disinfection step contact the footwear surface more effectively.

Q: Is the station suitable for livestock farm biosecurity?
A: Yes. It can be installed at controlled entrances between clean and dirty zones in pig, poultry, cattle and other livestock facilities.

Q: Does this model require an electric motor?
A: No electric motor specification is listed for the current model. The confirmed configuration uses a stainless steel structure, nylon brushes and PU liquid lines.