KC HD 10/23-4 S High-Pressure Washer

• Heavy-duty mobile high-pressure washer
• Water-cooled four-pole motor system
• Ceramic piston high-pressure pump
• Professional high-pressure spray gun and lance
• 10 m high-pressure hose
• Integrated fine water filter and mobile chassis

• 230 Bar Working Pressure: Strong cleaning power for stubborn farm and industrial contamination.
• 1000 L/h Water Flow: High flow rate improves rinsing efficiency on large surfaces.
• Water-Cooled Four-Pole Motor: Designed for reliable operation during demanding professional cleaning work.
• Ceramic Pistons: Wear-resistant pump components support extended service life.
• Pressure Cut-Off: Automatically stops pressure generation when the trigger gun is released.
• Fine Water Filtration: Integrated filter helps protect the pump from particles in the water supply.
• Easy Service Access: Wide-opening housing simplifies inspection and maintenance of key components.
• 10 m High-Pressure Hose: Provides practical working range inside barns and farm service areas.
• Heavy-Duty Mobility: Upright frame and large wheels allow easier transport between cleaning locations.

• Pig house floor and wall cleaning
• Farrowing crate and gestation stall cleaning
• Piglet nursery pen cleaning
• Cattle and poultry building cleaning
• Feeders, drinkers and farm equipment washing
• Livestock transport vehicle cleaning
• Farm machinery and workshop cleaning
• Concrete floors and loading areas
• Pre-cleaning before approved farm disinfection procedures

• Confirm that the electrical supply matches the required three-phase voltage and frequency before connection.
• Connect the machine to an adequate clean-water supply before starting the motor.
• Never operate the high-pressure pump without water.
• Inspect and clean the water inlet filter regularly to protect the pump.
• Check the high-pressure hose, fittings, spray gun and lance before each cleaning operation.
• Release system pressure before maintenance or accessory replacement.
• Check pump oil level and follow the recommended maintenance interval.
• Protect the machine and pump from freezing during cold-weather storage.
• Never direct the high-pressure jet toward people, animals, electrical equipment or delicate surfaces.
• Store the washer in a dry and protected location after use.

Q: What is the working pressure of this washer?
A: The HD 10/23-4 S provides a working pressure of approximately 230 bar, with maximum pressure up to about 253 bar.

Q: What is the water flow rate?
A: The rated water flow is approximately 1000 liters per hour.

Q: Is it suitable for commercial pig farms?
A: Yes. Its high pressure and large water flow make it suitable for intensive cleaning of pens, floors, walls, crates, feeders and farm equipment.

Q: Does the machine heat the water?
A: No. It is a cold water high-pressure washer without an integrated heating system.

Q: What power supply is required?
A: The corresponding HD 10/23-4 S configuration uses three-phase 400 V, 50 Hz electrical power.

Q: What is the maximum inlet water temperature?
A: The specified maximum inlet water temperature is 60°C.

Q: Why are ceramic pistons used?
A: Ceramic pistons offer high wear resistance and are suitable for repeated high-pressure professional cleaning applications.

Q: Does the washer stop when the trigger gun is released?
A: Yes. The pressure cut-off system stops pressure generation when the trigger is released, helping reduce unnecessary operating load.

Q: Can the high-pressure jet be used directly on animals?
A: No. High-pressure water must never be directed at livestock, people or other vulnerable targets.