| Product Name | Sow Artificial Insemination Back Clip | ||||||||||||||||
| Product Image |  |
||||||||||||||||
| Product Overview | The Sow Artificial Insemination Back Clip is a flexible breeding accessory designed to be positioned across the sow's lower back during artificial insemination. Its polypropylene construction provides flexibility for different sow body sizes, while the back-clamp structure creates gentle pressure and simulates the physical contact of a boar during natural mating. The design is intended to help reduce semen backflow and allow technicians to continue working without manually maintaining back pressure throughout the insemination process. | ||||||||||||||||
| Product Gallery | The product gallery presents the back clip structure, flexible polypropylene body, stainless steel tube and typical placement on the sow during artificial insemination. | ||||||||||||||||
| Key Features |
|
||||||||||||||||
| Working Principle | The back clip is placed around the sow's lower back after the insemination catheter has been positioned. The flexible clip applies controlled contact and pressure to the sow's back, providing a tactile stimulus similar to the physical contact of a boar. This allows the technician to work without continuously pressing the sow's back by hand. The back-pressure stimulus is intended to support the sow's natural standing response and help reduce semen leakage during the insemination procedure. The device is an auxiliary breeding tool and does not replace correct estrus detection or proper insemination technique. | ||||||||||||||||
| Technical Specifications |
|
||||||||||||||||
| Applications |
|
||||||||||||||||
| Installation & Maintenance | Before use, check the polypropylene body and stainless steel tube for cracks, deformation or loose components. During artificial insemination, position the clip securely across the sow's lower back without excessive pressure. Ensure that the device does not interfere with the insemination catheter or cause discomfort to the animal. After use, clean the clip and remove visible contamination. Disinfect it according to the farm's biosecurity procedures and allow it to dry before storage. Store the product in a clean, dry location away from excessive heat and direct sunlight. | ||||||||||||||||
| Product FAQ |
Q: What is the Sow Artificial Insemination Back Clip used for?
A: It is used during sow artificial insemination to provide back pressure, simulate boar contact and help reduce semen backflow. Q: Where is the clip positioned?
A: It is positioned around the sow's lower back or loin area during the insemination procedure. Q: What material is the back clip made from?
A: The main clip body is made from polypropylene plastic and the support tube is made from stainless steel. Q: Can it fit different sow body sizes?
A: Yes. The flexible polypropylene structure is designed to accommodate sows with different body sizes and conform to the back area. Q: Does the clip replace manual back pressure?
A: It is designed to provide continuous back pressure during insemination, reducing the need for the technician to manually maintain pressure. Q: Can it increase conception rate?
A: The product is designed to help reduce semen backflow and provide reproductive stimulation during insemination. Actual conception performance depends on estrus detection, insemination timing, semen quality, sow health and overall breeding management. |
Comments & Inquiries
Leave your questions or requirements below. We will reply as soon as possible.